Reunion – Beaver Creek, CO

This lift provides an easier egress option from McCoy Park than the cat track from the top of McCoy Park Express.
As of 2022, this is the only new build fixed grip lift at Beaver Creek.
View back down the lift line.
Tower 9.
Upper part of the line.
This lift unloads just above the Upper Beaver Creek Mountain and Strawberry Park Express lift summits.
Unloading area.
Drive terminal and upper lift line.
This is a relatively rare Alpenstar terminal without tensioning.
View from the top.
Looking down the skiable part of the line.
Most of the lift line is over a ravine and not skiable.
View leaving the lower station.
Looking back down into McCoy Park.
Loading area.
View riding up.
Middle part of the line.
Drive bullwheel and motor room.

15 thoughts on “Reunion – Beaver Creek, CO

  1. Skicoloraxo February 4, 2022 / 3:22 pm

    Thanks Peter for putting these up so quick


  2. Donald Reif February 4, 2022 / 5:30 pm

    I think this is the first brand-new fixed grip lift at Beaver Creek since the first Larkspur lift was built.


  3. Muni February 5, 2022 / 10:23 am

    I’m not sure fixed-grip was the right call here. I rode this lift on a sunny Saturday and spent more time stopped than moving. This might have been due to an overly-ambitious operating line speed. But the nature of skier using it is obviously also a big factor.

    Reasons it should be fixed-grip:
    – it’s shorter than 3000′ … IMHO most lifts above 4000′ should be detachable and most under 3000′ should not
    – it’s an egress lift
    – it’s nearly devoid of lappable terrain (the cat track in from Strawberry Park is exceptionally flat)
    – you can avoid it (it’s easy to exit this area from the top of McCoy Park Express
    – everyone should learn how to load a fixed-grip lift … even at Beaver Creek

    Reasons it should be detachable:
    – The skiers using this area (and for whom it is targeted) are …
    – more likely to be rather inexperienced
    – more likely to be young kids
    – It’s beaver creek. the same resort that put a detachable gondola on a 1700′ bunny slope
    – it’s a premier Vail destination
    – Sourdough Express at Vail is 300′ shorter than this lift
    – High Meadow Express at Park City is ~800′ shorter

    I’d be very curious if there was a healthy amount of debate when planning this area.


    • jcpierce05 February 5, 2022 / 1:18 pm

      There’s no doubt this lift should have gone detachable. Same thing happened to me last weekend, it took me over 10 minutes to get up the lift with all the stops and starts. It would probably help with the mis-loads if there was a carpet and gates at the base and it would allow them to run it faster. Arguably, this long, slow fixed-grip doesn’t look too good at a luxury resort like Beaver.

      It would also have been a good idea to start the lift between towers 2-3 and have some sort of a trail pod off this lift. If they had done that, the lift would have warranted a detachable and would have allowed families with different skill abilities to ski somewhat in the same area. I also would have had the lift terminate higher up on the ridge, allowing improved access to the rest of McCoy and Larkspur too.


      • Donald Reif February 8, 2022 / 9:13 pm

        The carpet would probably be on brand for a resort like this.


      • Greyson February 10, 2022 / 8:25 pm

        That would be a lot of money for 1 more run. A lift terminal has to have a large amount of flat land so the bottom of a ravine isn’t a good spot. Also the lifts reason is to allow people skiing in McCoy park to get back to Straberry and to the future restaurant instead of being a lift that is circuited. I don’t think that the costs of a detachable would be worth it. And a chair is better then a pulsed movement gondola in this application as the McCoy park lift is a chair so it should be assumed anyone taking this lift should be able to ride a chair. If someone can’t ride a chair they should be on Highlands trying to figure it out.


    • Greyson February 10, 2022 / 8:26 pm

      When they were first planning this area they actually didn’t have plans for this lift.


      • Donald Reif February 10, 2022 / 9:44 pm

        More like the lift was on and off the master plan. There were a few points right up until they gave the greenlight for construction where Reunion wasn’t part of the plans. It was probably a good idea to greenlight it because it ensures that if the McCoy Park Express goes down, you won’t be stuck here.


  4. afski722 February 10, 2022 / 8:54 pm

    Its an egress lift….its intent is really only to exit the area. HSQ would be total overkill in terms of capacity / cost.
    Yes, they easily could’ve opened this area without the lift in the first place.

    I highly doubt anyone is completely turned-off from BC because of one measly fixed-grip egress lift.


    • Donald Reif February 10, 2022 / 9:45 pm

      Most people are also only ever going to use it once during their day.


    • Donald Reif February 10, 2022 / 9:50 pm

      I mean, McCoy Park is kinda like Keystone’s Outback, although in the case of leaving the Outback, riding Wayback is mandatory. And the inverse of Peak 6 at Breck, where although it’s possible to reach the Kensho SuperChair directly from Pioneer Crossing without riding the Zendo Chair, Zendo is the primary access route.


  5. pbropetech February 28, 2022 / 7:11 pm

    Rode this today and it absolutely does not need to be a detach. I admit it was Monday, but most people were trying to figure out how to get over to chair 11 rather than ride a fixed-grip. No-one was riding this.


    • skitheeast February 28, 2022 / 7:35 pm

      I totally agree. This lift is really unnecessary unless McCoy Park goes down. No need for a detachable.


  6. New England Chairlifts & Skiing April 16, 2022 / 8:58 am

    Does Doppelmayr still offer traditional footrests or have they completely switched over to these ugly “puck” footrests? All the new Doppelmayr lifts in 2021 seem to have the pucks. They do not look comfortable at all to me.


    • pbropetech April 16, 2022 / 8:47 pm

      Probably buyer’s choice. They definitely still manufacture them as replacements.


Leave a Reply to Donald Reif Cancel reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s